1) wat benefit i can get by changing the value of transmit-delay from 1 to something else ???
2) is there any possible way of preferring inter-area routes over intra-area ?? i checked ospf faq and it said that we cant but we can do it also by changing the ospf process, my question is can i do it without changing the process ???
As for OSPF I do not believe that there is any way to get OSPF to prefer an inter-area route over an intra-area route. I am not clear what kind of change you could make in the OSPF process that would do this.
To set the estimated time required to send a link-state update packet on the interface, use the ip ospf transmit-delay .
Link-state advertisements (LSAs) in the update packet must have their ages incremented by the amount specified in the seconds argument before transmission. The value assigned should take into account the transmission and propagation delays for the interface.
If the delay is not added before transmission over a link, the time in which the LSA propagates over the link is not considered.
****** This setting has more significance on very low-speed links.
The following example sets the retransmit delay value to 3 seconds:
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.