Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

transport PAgP over dot1q tunnel

Hi all,

I have a Catalyst 4507 with SUP7L-E running cat4500e-universalk9.SPA.03.03.00.SG.151-1.SG.bin.

The network diagram is attached.

I'm trying to transport PAgP over dot1q tunnel but PAgP packets are not carried from one site to the other on any direction.

The configuration on 4500 interfaces is:

interface GigabitEthernetx/y

switchport access vlan X

switchport mode dot1q-tunnel

l2protocol-tunnel cdp

l2protocol-tunnel lldp

l2protocol-tunnel stp

l2protocol-tunnel vtp

!

I cannot find the command 'l2protocol-tunnel point-to-point pagp'. Is it supported?

I did the same test with LACP but it didn't work.

Can you help me?

Regards

Stefano

1 REPLY
Community Member

Re: transport PAgP over dot1q tunnel

Network diagram attached                  

270
Views
0
Helpful
1
Replies
CreatePlease to create content