Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

troncal inconvinient

have a 3640 router and a switch with vlans in it. I want to use the (router in a stick method) but, when I create the sub-interface to specify (vlan-1) as the native vlan, the sub-comand (native)dos not appear after I have put (Router(config-subif)#encapsulation isl 1)

please I need you to tell me if there is another way to to do this in this router or if there is another sub-coman instead

of (native)

thanks

1 REPLY
Hall of Fame Super Bronze

Re: troncal inconvinient

You need to use dot1q if you need native keyword. ISL tags all Vlans therefore it doesn't have a concept of native Vlan as native Vlan's definition is, a Vlan with untagged packets.

HTH,

__

Edison.

115
Views
0
Helpful
1
Replies
CreatePlease to create content