Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Trouble Removing 3750 from stack

Hi all,

I have a 3750 on my desk which I’m using for new site, I removed this from a previous stack of 4 configuration.

I ran the no switch 4 provision ws-c3750g-24ts on the stack after I powered it down and removed it. (no problems it was switch 4)

I then erased the startup config and reloaded , I went through the basic setup wizard etc and set it up, however the intefaces are still named like they were in the stack.

Ie 

interface GigabitEthernet4/0/1

!

interface GigabitEthernet4/0/2

!

interface GigabitEthernet4/0/3

also switch 4 provision ws-c3750g-24ts is in the config on this switch (is this strange?)

I tried the no switch 4 provision ws-c3750g-24ts on this but the result is

SW1(config)#no switch 4 provision ws-c3750g-24ts

%Switch can not be un-provisioned when it is physically present

Its not a real problem as the switch will still work but I would like to keep it tidy?

1 REPLY
Purple

Re: Trouble Removing 3750 from stack

  Try "switch 4 renumber 1 ,  save and reload .

6785
Views
0
Helpful
1
Replies
CreatePlease to create content