Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Troubles Adding Switches to a Stack

I inherited a switch stack consisting two Cisco WS-C3750X-48T-S switches to which I'm trying to add two more switches of the same make and model (also I downgraded these two newer switches to an older image version so all four switches match). However my attempts to join these two new switches to the stack has failed. The current switch stack does not see the new switches. I ensured my StackWise cabling was correct by following the documentation linked below but still no success.

http://www.cisco.com/c/en/us/support/docs/switches/catalyst-3750-series-switches/71925-cat3750-create-switch-stks.html#stack3

The two new switches are not seen by our current stack, and oddly enough these new switches formed their own stack so now I have two seperate stacks instead of one. An attempt had been made earlier by another tech but the images weren't the same between the older and newer switches, so I wondering if this initial failed attempt may be preventing the switches from joining the stack. An troubleshooting ideas are definitely welcomed. Thanks!

Everyone's tags (3)
1 REPLY
Silver

Troubles Adding Switches to a Stack

Hi,

There can be many reasons for the switches not joining the stack like SDM template mismatch.

You may go through the following document:

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750/software/troubleshooting/switch_stacks.html#wp40112

Thanks

Ankur

"Please rate the post if found useful"

187
Views
0
Helpful
1
Replies
CreatePlease to create content