Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Troubleshooting configuration register issues

Hello,I mistakenly change my 2620 router configuration register value to 0x1202.How can I set my pc hyperterminal to communicate with the router as it has not been able to communicate with it since then.I understand that such value has changed the default console speed to 1200.I have tried to change the baud rate on the PC to 1200 to no avail.

I will be glad if I could be helped to restore it to it default value

4 REPLIES

Re: Troubleshooting configuration register issues

Hi

U need to try one by one all the baud rate available on u r terminal in order to get access to the router n change the value to 0x2102.

Thanks

Mahmood

Re: Troubleshooting configuration register issues

Hi,

In hyperterminal go to the properties and configuer and change the baud rates and check.

Regards,

Pravin

New Member

Re: Troubleshooting configuration register issues

HI Pravin,

Thank u for the message you sent to me.I have fixed up the problem.I tried to use all the baud rate one after the other and one of it works out.

Thanks alot for that clue

New Member

Re: Troubleshooting configuration register issues

Hi Mahmood,

Thanks for your message.I have fixed up the problem.I tried to use the baud rate one after the other as u suggested and one of it works out.

Thanks alot for the clue

125
Views
10
Helpful
4
Replies