Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trunk between Cisco Catalyst and DLINK DES-7210

Hi,

i would like to configure a Trunk with all VLANs between a Cisco Catalyst 3650 an a DLINK DES-7210.

On the DLINK is the def. GW via VRRP defined.

Now i get the following Error:

%ARP-4-DUPADDR: Duplicate address 172.28.72.1 on interface VLAN 72 port TenGigabitEthernet 5/3, sourced by 24e9.b397.2c34

This is the Uplink Interface on the Cisco Switch.

What can cause this?

here`s the config of the Cisco Port:

interface TenGigabitEthernet1/1/4

switchport mode trunk

switchport nonegotiate

load-interval 30

udld port disable

spanning-tree bpdufilter enable

end

sh inter trunk

Port        Mode             Encapsulation  Status        Native vlan

Te1/1/4     on               802.1q         trunking      1

Port        Vlans allowed on trunk

Te1/1/4     1-4094

Port        Vlans allowed and active in management domain

Te1/1/4     1,8,12,16,20-24,32,36,40,44,48,56,64,68,72,76,80,88,92,96,201,211,239-242,244-249,260,264,268,1212,1216,1220,1224,1228,1232,1234,1236,1240,1244,1248,1252,1256,1260,1264,1268

Port        Vlans in spanning tree forwarding state and not pruned

Te1/1/4     1,8,12,16,20-24,32,36,40,44,48,56,64,68,72,76,80,88,92,96,201,211,239-242,244-249,260,264,268,1212,1216,1220,1224,1228,1232,1234,1236,1240,1244,1248,1252,1256,1260,1264,1268

and here is the DLINK Switch:

interface TenGigabitEthernet 5/3

switchport mode trunk

description test

sh int ten 5/3 trunk

Interface                Mode   Native VLAN VLAN lists

------------------------ ------ ----------- ----------

TenGigabitEthernet 5/3   On     1           ALL

1 REPLY
Hall of Fame Super Blue

Trunk between Cisco Catalyst and DLINK DES-7210

Do you have the same IP configured on both switches ?

Jon

1012
Views
0
Helpful
1
Replies
CreatePlease login to create content