I am using Nortel 5650TD and Cisco 2960S switches. Vlan 50 is a managmnet Vlan for nortel and the same Vlan 50 as configured as a trunk native Vlan on Cisco side. Vlaan 50 has IP address which i need to use for managmnet of switch.
Vlan 10 has configured as access vlan for all other ports on nortel and cisco switches.
Now when i connect the uplink on trunk ports, Iam getting the error message "%SPANTREE-2-RECV_PVID_ERR: Received BPDU with inconsistent peer vlan id 1 on GigabitEthernet1/0/48 VLAN50 "
Port 48 Configured as trunk port with native vlan of 50. Ports 1-47 configured as access port for vlan 10.
Port 48 Configured as trunk port with Deafult Vlan 50. And tagging enabled except for the vlan 50. Port 1-47 Configured as access port for vlan 10.
1. Tried Switchport mode trunk with no native vlan concept & tagged all vlan in Nortel side- No luck.same error.
2. Tried BDUP filter off on cisco side-
3.Configured MST On nortel side.
4. configured Vlan 1 has with Managmnet IP address.
So is there any solution for this problem? vendor came so many times and he blames that nortel to configured more.But i hope there no further thigs avavilble in Nortel except MST and Tag and Un Tags. Plaese share your ideas...
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...