Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Trunk link between cisco and juniper mx960 on aggregated interfaces

Hello , I need to link a Cisco me3400 and a juniper MX960.

I need to reach each gw located on my mx960 from the devices  connected to the vlans 2,3 and 4 on the cisco me3400 in layer 2, then I  will route each subnet.

I wonder if the lines I wrote will work, here is a picture:

Please let me know if it sounds good for you.

Thx.

Core_proposed_changes.png

529
Views
0
Helpful
0
Replies
CreatePlease to create content