Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trunk port failover on SE V 4510R Switch

Hello,

We have a new 4510R that needs to have the failover configured from one SE to the other SE. We've setup the trunk ports on the active supervisor on Gi1/1 - 1/2 and need to set this up on Gi2/1 - 2/2 not sure where to begin. What are the options on this failover and what commands are needed to set this up.

Thanks in advance.

Tony

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Trunk port failover on SE V 4510R Switch

1 REPLY
Bronze

Re: Trunk port failover on SE V 4510R Switch

134
Views
0
Helpful
1
Replies