Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trunk port on 3560-X

I'm trying to setup a trunk port so that I can have multiple VLANs on the same port.  In testing, I'm just trying to get a workstation to connect on one of the VLANs with a static IP but it just doesn't work.  The int shows up, up, but I can't ping the switch or anything else.  If I turn off the trunk and just set the port to access mode with a specific VLAN it works fine.   It's running lanbase could that be it? 

Here is the config on the port.  What is missing?

interface GigabitEthernet0/6

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 8,10

switchport mode trunk

end

Everyone's tags (1)
1 REPLY
VIP Purple

Trunk port on 3560-X

The config is fine for a trunk and Lanbase is of course capable of trunking. I would more assume that the NIC on the PC is configured in a wrong way.

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni


--
Don't stop after you've improved your network! Improve the world by lending money to the working poor: http://www.kiva.org/invitedby/karsteni
111
Views
0
Helpful
1
Replies
CreatePlease login to create content