The switch ports are now set to Auto for speend and duplex. In this case the trunk establishes between switches if the switch port mode is set to trunk. If at one end the spped or duplex is set manually the trunk disconnects and the port status says "disconnected"
My guess is that you have auto mdix on and you are using a straight thru cable . Auto mdix will only work when the ports are set as auto . Turn auto mdix off on the ports , use a crossover cable and you should be able to hardcode the ports if you want though you really don't need to between pieces of cisco gear as their autonegotiate function works well. If you set both ports in your current setup to auto for speed and duplex the trunk should work normally also .
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.