Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
New Member

Trunking from 881W to WLAN Service Module

Should I be able to trunk multiple VLANs between an 881w and its installed wlan-ap service module?

I can route between the 2 as long as I set up a subnet on vlan1, but I cannot get anything going if I create VLAN100 on the router and the service module and put the IP address on the service module.

I've created int g0.100 and given that encapsulation dot1q 100, I set bridge-group 100

on BVI100 I've set the IP

on the router I've set interface Wlan-GigabitEthernet0 to switchport mode trunk

I've created vlan100 and set an IP (for testing) of

I cannot ping between the two.

any suggestions?

Everyone's tags (3)
CreatePlease to create content