Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

trunking

Hello I am trying to figure out how to trunk between a catalyst 2950 and a 1900 ..I've either overlooked something in my book or else am missing the whole thing..any and all help greatly appreciated..

thank you

1 ACCEPTED SOLUTION

Accepted Solutions

Re: trunking

Hi,

The 2950 switch only does 802.1Q trunking. The 1900 switch only does ISL trunking

(supports up to two Fast Ethernet ISL trunks, does not support 802.1Q) so we cannot trunk

directly between the 2950 and the 1900 switch.

Unfortunately, there is no configuration

that we can do to make them "trunk". The only way to implement vlan mangement between

these two platforms is by physically

connecting links equal to the number of vlan's configured on the switches to carry

different vlan traffic. Obviously, this could only be a workaround and not very scalable

due to physical port limitation.

Regards,

Jagdeep

Note : If that helps then please mark this thread as solved, so that others can benefit from it.

5 REPLIES

Re: trunking

A couple of commands, like the one shown below, on interfaces connecting both switches should get the basic trunk going. Thereafter any configuration can be used to fine tune the trunk.

int f0/1

switchport trunk encapsulation dot1q

switchport mode trunk

You can use dot1q or ISL as the trunk encapsulation type.

HTH

Sundar

New Member

Re: trunking

here is the issue with these two switches...the 1900 only does ISL and not the DOT1Q and the 2950 does DOT1Q so am at a mega loss here...this is for my CCNA studies thus the questions

New Member

Re: trunking

The 1900 will only do ISL trunking, and only on the 100baseT ports. (You can't ever form a trunk on 10baseT ports).

HTH,

Paul

New Member

Re: trunking

true and 10baseT is way to slow to trunk off anyways...lol give me bandwidth!!

Re: trunking

Hi,

The 2950 switch only does 802.1Q trunking. The 1900 switch only does ISL trunking

(supports up to two Fast Ethernet ISL trunks, does not support 802.1Q) so we cannot trunk

directly between the 2950 and the 1900 switch.

Unfortunately, there is no configuration

that we can do to make them "trunk". The only way to implement vlan mangement between

these two platforms is by physically

connecting links equal to the number of vlan's configured on the switches to carry

different vlan traffic. Obviously, this could only be a workaround and not very scalable

due to physical port limitation.

Regards,

Jagdeep

Note : If that helps then please mark this thread as solved, so that others can benefit from it.

120
Views
0
Helpful
5
Replies