cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1367
Views
0
Helpful
0
Replies

Trying to solve this schema is this correct?

KMVMMV01123
Level 1
Level 1

I'm trying to solve this schema, I been working on it a couple of hours, have I done it right? If I haven't can you please correct me?

Given the following schema, perform the corresponding subnets design,    taking into consideration that you must take advantage of the maximum    quantity of IP's available.

172.16.0.0 255.255.0.0 is a /16 network.

R1 network --> 40 hosts /26

R3 SW 4 network --> 70 hosts /25

R3 SW 5 network --> 80 hosts /25

R2 network for SW2 SW3 --> 150 hosts /24

Wireless R4 --> This one will use NAT probably, so it can be 192.168.1.0 /24 as default.

Networks between routers:

R1-R2 --> /26 (because there is a switch between them)

R3-R2 --> /30

R2-R4 --> /30

So there are 7 networks. IP schema:

R3 hosts SW4: 172.16.1.0 255.255.255.128 for 70 hosts

R3 hosts SW5: 172.16.1.128 255.255.255.128 for 80 hosts

R3 to R2: 172.16.2.0 255.255.255.252 for two interfaces

R2 hosts SW2/3: 172.16.0.0 255.255.255.0 for 150 hosts

Between R2 and R1: 172.16.2.0 255.255.255.192 for ~38 hosts

R2 to Wireless R4: 172.16.2.4 255.255.255.252 for two interfaces

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco