When you generate the ping packet your end station specifies the TTL of the packet. When the other device generates the ping response it specifies the TTL of the response packet. It is likely that a PC, or a Router, or an HP server might specify different TTL values. So depending of what the remote device specifies as the TTL, and depending on how far away they are (how many hops are decremented in the TTL) it is reasonable that you would get different results in your ping.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...