Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Tunnel GRE with Loopback

Hello,

Could you please tel me how i can use a loop back with a tunnel GRE ?

Thanks you.

4 REPLIES

Tunnel GRE with Loopback

Are you wanting to use it as source/destination for the tunnel termination, or are you just wanting to advertise the loopback over the tunnel?

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***
Community Member

Re: Tunnel GRE with Loopback

hi John,

is to put in a next hop for route map,therefore, source / destination, is not it?

James,

Re: Tunnel GRE with Loopback

You can apply a next-hop to a tunnel interface. For example if you have 2 ends of a tunnel:

192.168.1.1 - side A

192.168.1.2 - side B

Your route-map on side A can set a next-hop to 192.168.1.2 to force traffic over the tunnel if needed....

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***
Community Member

Tunnel GRE with Loopback

That is doesn't working,i wat just how set up a lookback whith a tunnel GRE plz,

194
Views
0
Helpful
4
Replies
CreatePlease to create content