Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Tunnel Problem

Dear all,

I just got a new Cisco 3560PC-S (8 port) whose installed IOS is 12.2(35r)SE2. I am trying to configure GRE tunnel on it using interface tunnel 1 command... But it is not taking it.. other crypto commands are not running as well.... Can anyone suggest the proper IOS to which when I upgrade, I get the required results? Thanks in advance

Sheeraz

2 REPLIES

Re: Tunnel Problem

Sheeraz,

Are you talking about the Catalyst 3560-8PC? If you are, it's a layer 2 switch, tunnels and Crypto are layer 3 functions, see:-

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_35_se/configuration/guide/scg1.html

and http://www.cisco.com/en/US/products/hw/switches/ps5528/prod_configuration_examples_list.html

I think you are trying to configure services that are just not available in the hardware.

HTH.

Hall of Fame Super Blue

Re: Tunnel Problem

Sheeraz

Andrew is correct in that as far as i know the 3560 doesn't support these features. Not because it is a layer 2 switch because it isn't only L2 it can support IP routing etc. so it is a fully L3 capable but still it does not include these features.

Jon

111
Views
0
Helpful
2
Replies