Twingig Conversor does not reconnect after reload ou power on.
I have three switches on cascading as you can see attached but when I need to reload or power off and power on late the uplink couldn't link up and I need to remove and put in again the CAB-SFP-50CM as you can see attached to reconnect the uplink.
Anyone know how can I fix this issue?
I am using the twingig conversor module with 3560-e.
Re: Twingig Conversor does not reconnect after reload ou power o
you are clearly in a lab environment and you have interconnected your switches in this peculiar way.
Probably the problem origins from using this special cable with the twingig
For example I've found the following notes:
When a Catalyst 3560 Switch is connected to a Catalyst 3750 or any other type of Catalyst switch model, you cannot use the CAB-SFP-50CM= cable. You can connect both switches using a copper cable with SFP (GLC-T) on both devices instead of a CAB-SFP-50CM= cable.
Only Catalyst 3560-E switches. The SFP module patch cable is a 0.5-meter, copper, passive cable with SFP module connectors at each end. The patch cable can connect two Catalyst 3560-E switches in a cascaded configuration.
However, your setup is considered a valid setup see
2The Catalyst 3560-E switch supports the SFP module patch cable, a 0-5-meter, copper, passive cable with SFP module connectors at each end. The patch cable can connect two Catalyst 3560-E switches in a cascaded configuration.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...