Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

two routes summarise

We are running OSPF routing protocol and we want to dvertise only the two summarize routes 10.8.0.0/16 and 10.4.0.0/16 on our perimeter devices(cisco routers) which are connected to our collabarative network.

Is it possible to advertise two sumarize router 10.8.0.0/16 and 10.4.0.0/16 ?

3 REPLIES

Re: two routes summarise

Can you post the config of the router ??

Re: two routes summarise

Hi Azmath,

Based on the scarce information I have from your post, I can ask you the following:

Why don't you advertise the summarized route of the 2 above: 10.0.0.0/12 ?

Cheers:

Istvan

Re: two routes summarise

But finally, if you want, you can use the "area range" command multiple times to advertise the 2 summaries.

Cheers:

Istvan

157
Views
0
Helpful
3
Replies