Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

ubr-rfsw

Hello,

Can anyone explain to me what the difference is between a ubr-rfsw and a ubr-rfsw-3x10? Thanks.

2 REPLIES
Anonymous
N/A

Re: ubr-rfsw

The Cisco uBR-RFSW RF Switch provides the physical cabling support for the N+1 Redundancy for the Cisco CMTS feature, which allows a single cable interface to act as the protect interface for up to 7 cable interfaces in the Cisco uBR10012 router, thereby significantly reducing the cost of providing redundant operation. The cable interface connections are made through the Cisco uBR-RFSW RF Switch, which provides the connections required for both upstream and downstream port redundancy. The Cisco uBR 3x10 RF Switch is designed to work with the Cisco uBR10012 CMTS or the isco uBR7246VXR CMTS in a cable headend or hub to provide N+1 redundancy for applications such as Voice over IP (VoIP).

The Cisco uBR 3x10 RF Switch is a rack-mount unit that contains the RF combiners and splitters, RF switches, and switch drivers. The RF switch uses Cisco RF Switch logic, and a Simple Network Management Protocol (SNMP) control interface. The Cisco uBR 3x10 RF Switch can be controlled using SNMP from the Cisco uBR10012 CMTS or the Cisco uBR7246VXR CMTS.

New Member

Re: ubr-rfsw

Thanks for the info.

336
Views
0
Helpful
2
Replies
CreatePlease to create content