The problem is, that I recently chenged the IP address of Vlan1 using the command line on the router. However I'm now unable to access the router at-all using the HTTP BUI or using the Cisco Configuration app. It just says "Discovery failed" whenever I attempt to connect with an error of;
"Connection to the device could not be established. Either the device is not reachable or the HTTP service is not enabled on the device."
I thought at first the problem may have been to do with access lists, but I've got access list one set to permit any. So can't see what the problem is.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.