Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

unable to access standby sup engine

the ws-x6k-s2u-msfc2 is the standby sup engine and a ws-x6k-sup2-2ge is the primary. when removing the primary and starting to boot the secondary it hangs and goes to rommon but unable to type. if i place console cable into standby not able to type.

1 REPLY
New Member

Re: unable to access standby sup engine

This issue may be due the slot that supervisor engine is mounted. If the slot is different and if you access wrong slot then the suervisor cannot be accessed.

107
Views
0
Helpful
1
Replies