Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Unable to breack the password of 6509 Switch with Sup720

Hi Guys,

I have a 6509 Switch with single Sup 720 with basic configuration.But i m unable to break the password of this.I have tried all the methods which have mentioned on the cisco site.

Can anybody tell me that what could be the other method for breaking the password other than change the register value???

I am also trying to take the switch back on default settings but not successful till now.

Any suggestions will welcome & appreciate!!!

Regards,

Loyal2Cisco

3 REPLIES
VIP Super Bronze

Re: Unable to breack the password of 6509 Switch with Sup720

If your config register has not been changed to ignore break, this link should help you:

http://www.cisco.com/en/US/products/hw/switches/ps708/products_password_recovery09186a00801caa95.shtml

HTH

Reza

New Member

Re: Unable to breack the password of 6509 Switch with Sup720

Hi Reza,

I have done this same already.Because in my case, my sup engine is going in rmon mode continuously & after giving the boot command then it comes in user mode & asking for the password.

Thanx for ur hlp!

Regards,

Re: Unable to breack the password of 6509 Switch with Sup720

Rohit,

To perform password recovery you need to do it when the right after the RP gains control of the console port. Please see the following link.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_password_recovery09186a00801caa95.shtml#topic1

HTH,

Mark

514
Views
0
Helpful
3
Replies
CreatePlease to create content