cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1376
Views
0
Helpful
13
Replies

unable to enable routing in 3750x switch

EZRA SHYAM
Level 1
Level 1

im unable to enable ip routing in the WS-C3750X-24T-L switch. Tried with SDM prefer routing option but still same issue.

Can some suggest on this?

MOdel: WS-C3750X-24T-L

IOS :flash:c3750e-ipbasek9-mz.122-55.SE5.bin

sh license

Index 1 Feature: ipservices

        Period left: 0  minute  0  second

Index 2 Feature: ipbase

        Period left: 0  minute  0  second

Index 3 Feature: lanbase

        Period left: Life time

        License Type: Permanent

        License State: Active, In Use

        License Priority: Medium

        License Count: Non-Counted

                  

regards,

Ezra.

13 Replies 13

Sandeep Choudhary
VIP Alumni
VIP Alumni

Did u tried:

Switch(config )# ip routing

Regards

Sent from Cisco Technical Support iPhone App

hi sandeep,

there is no option to enable ip routing in the switch.

(config)#ip routing

                      ^

% Invalid input detected at '^' marker.

Hi,

Pls enable this command

sdm prefer lanbase-routing

reload the switch & then try

Pls rate if helpful

Br/Suibhojit

HI Ezra,

Please update your licence.

Contact your cisco supplier, and buy the upgraded license.

Regards

Dontforget to rate helpful posts.

Index 3 Feature: lanbase

        Period left: Life time

        License Type: Permanent

        License State: Active, In Use

You don't have the license to run routing. 

So the only option is to enable licence?

Index 1 Feature: ipservices

        Period left: 0  minute  0  second

You can't enable the IP Services DEMO license because you've used it all up.

Your only option is to purchase the IP Service license from your authorized Cisco reseller.

HI,

Hope you have tried this option

Pls enable this command

sdm prefer lanbase-routing  ---> this is to help us to enable 'ip routing' with non routing supported image

Reload the switch & then try to enable 'ip routing'

Br/Subhojit

Update the new image which supports ip routing .

Regards

Sent from Cisco Technical Support iPhone App

Hi suibhojit,

i dont have option to enable the option sdm prefer lanbase-routing.

config)#sdm prefer ?
  access              Access bias
  default             Default bias
  dual-ipv4-and-ipv6  Support both IPv4 and IPv6
  routing             Unicast bias
  vlan                VLAN bias

HI,

Just check with routing once,

then reload & try to give 'ip routing'

Br/Subhojit

tried with that... but no luck.

HI,

Pls share this command output & also ISP version

sh sdm prefer routing

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: