Unable to ping switch from console or VTY session.
I have a switch with one VLAN that is up and operational. Passing traffic ok. I can ping telnet to the switch with no problem from other devices. From the switch I can ping other devices no problem. I cannot ping the VLAN ip when consoled or in a VTY session on the switch. What am I missing. Any idea's?
Re: Unable to ping switch from console or VTY session.
You might have to post config to see if we can see anything . Can't think of anything that might cause what you are seeing . What kind of switch ? Is the uplink trunked at all ? Default gateway pointing to correct layer 3 routing address though you should be able to ping it directly if it is truly a single vlan and nothing else.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...