One switch is configured Layer 3 which does the LAN routing for the network it has one static route (ip route 0.0.0.0 0.0.0.0 10.0.0.1). configured with vlan 10 SVI as 10.0.0.254 and vlan 20 as 10.1.0.254
Each switch is assigned 10.100.0.x for it's vlan 1
For some reason I am unable to ping the vlan 1 ip for one of the switches from vlan 10 or 20 ... (Switch with vlan 1 -- 10.100.0.5) . I am able to ping the address of the switch with the issue from the CLI of the switches. When i do a tracert for the switches ip in question I get to the SVI / Default Gateway and then nothing.
Everything else works fine. Internet etc....
What am I missing? Some type of routing somewhere??
Here is the ip route from the Layer 3 switch
SW-A1#sh ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
Gateway of last resort is 10.0.0.1 to network 0.0.0.0
Well it turns out this weird problem was the fact i enabled ip routing on one of the switches I wasn't suppose to. Once I turned off ip routing and set the ip default-gateway things are now working correctly.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...