06-25-2014 06:44 AM - edited 03-07-2019 07:50 PM
rommon 2 >dir bootflash:
File Size (Bytes) File Name
---------------------------------------
33363113 cat4500e-entservicesk9-mz.151-1.SG1.bin
24842288 cat4500e-entservices-mz.122-54.SG.bin
Total space = 128282624 bytes, Available = 60153856 bytes
Read back invalid SEEPROM-1 data : is the SEEPROM programmed?
**********************************************************
* *
* Welcome to Rom Monitor for WS-C4948E System *
* Copyright (c) 2003-2011 by Cisco Systems, Inc. *
* All rights reserved. *
* *
**********************************************************
Checking the partition table and boot sector...
Checking FAT, Files and Directories...
Reclaiming unused space...
Updating FAT...
Rom Monitor Program Version 12.2(44r)SG10
CPU Rev: 2.1, Board Rev: 4, Board Type: 104, CPLD Hobgoblin Rev: 20
Chassis: WS-C4948E
Front Panel Phy is Bcm5482s
Got Mac Address: 50:3d:e5:5b:50:3f
MAC Address : 50-3d-e5-5b-50-3f
IP Address : 172.16.1.5
Netmask : 255.255.255.0
Gateway : 172.16.1.1
TftpServer : 172.16.1.1
Peer supervisor not detected or is not running IOS
Supervisor uplinks and all linecards have been reset
Established physical link 100Mb Full Duplex
Network layer connectivity may take a few seconds
rommon 1 >?
alias set and display aliases command
boot boot up an external process
clear clear configurations, use 'clear help' for more info
confreg configuration register utility
date displays the current date and time
dev list the device table with physical device information
dir list filesystem information
help monitor builtin command help
history monitor command history
macstats print management port MAC statistics counters
meminfo main memory information
ping ping utility to determine network connectivity
repeat repeat a monitor command
reset system reset
set show/set environment vars, use 'set help' for more info
sprom serial eprom operations
unalias unset an alias
unset unset a monitor variable
version display Rom Monitor version information
rommon 2 >meminfo
Main memory size: 512 MB.
NVRAM size: 512KB
rommon 3 >dev
Devices in device table:
Device id Name Size
--------- ----- ------
mem: Main Memory ( SDRAM ) 536870912
nvram: Non Volatile RAM 524288
bootflash: Internal Flash Memory 134217728 (filesystem capable)
rommon 4 >set
PS1=rommon ! >
Netmask=255.255.255.0
IpAddr=172.16.1.5
Broadcast=172.16.1.255
Gateway=172.16.1.1
RommonVer=12.2(44r)SG10
TftpServer=172.16.1.1
ConfigReg=0xc000
BootedFileName=bootflash:cat4500e-entservicesk9-mz.151-1.SG1.bin
rommon 5 >boot
Rommon reg: 0x00004380
Reset2Reg: 0x00009EFF
##
Fortooine controller 0x0B5C65BC..0x0B72EB33 original size:0x001C685D
##################
diagsk5 version 5.0.2.3
Irq9 Not active
Irq9 Not active
Irq9 Not active
Irq9 Not active
Irq9 Not active
Irq9 Not active
Irq9 Not active
Irq9 Not active
Irq9 Not active
Irq9 Not active
Error: FATAL ERROR: PCIE LINK FAILED
Warning: PCIE Link Retried for 10 times
UNHANDLED ROMMON EXCEPTION at PC=04838180
Vector=00000100 MSR=02029230 LR=04838174
MCSR=00000000
CISR0=00000000 CISR1=00800000
DDR_ERR_DETECT=00000000
Tell. Why it does not load and causing the error?
06-25-2014 03:53 PM
You'll need to RMA the appliance. Looks like it's dead.
06-26-2014 04:56 AM
Thank you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: