The sh counters command under some ports on WS-X6148A-GE-TX module, show the rxHCDropEvents increasing constantly. I get any or poor information about this counter on Cisco.com. Could be this counter related to any exhausted ASIC on this group of ports? Could be any hardware problem? I put the sh counters output on the output interpreter without any good help.
This seems to be cosmetic bug..rxHCDropevents accounts for Drops due to Broadcast supression (Storm Control feature) whereas 6148A doesn't support that feature and hence the counters ur getting seems to be inaccurate (it should be zero with this version of LC)...8.6(1) and higher should be able to address this issue.
-You might wanna check Hw/Sw compatibility
-If this doesn't address the issue, you might wanna call TAC to get further assistance at the ASIC level..
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...