Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Understanding SHOW INTERFACE

Hi!

One of our switches (WS-C3548-XL) in the server room is generating several errors on several interfaces. Here is one example:

FastEthernet0/2 is up, line protocol is up

Hardware is Fast Ethernet, address is 0002.166b.b342 (bia 0002.166b.b342)

Description: ***ACCESS PORT***

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive not set

Auto-duplex (Full), Auto Speed (100), 100BaseTX/FX

ARP type: ARPA, ARP Timeout 04:00:00

Last input never, output 00:00:00, output hang never

Last clearing of "show interface" counters 15:39:55

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 7000 bits/sec, 5 packets/sec

5 minute output rate 83000 bits/sec, 28 packets/sec

2353394 packets input, 420873627 bytes

Received 378 broadcasts, 0 runts, 0 giants, 0 throttles

1070 input errors, 1070 CRC, 0 frame, 4352 overrun, 4352 ignored

0 watchdog, 0 multicast

0 input packets with dribble condition detected

3550965 packets output, 1053192180 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

Where do I get information what could be causing the overruns, input errors, CRCs, etc.?

Regards, LLS71

3 REPLIES
Purple

Re: Understanding SHOW INTERFACE

Check the server nics to see how they are set . The switch is set for auto speed and duplex so the server nics must also be set for auto speed and duplex , they "cannot" be hardcoded to a specific speed and duplex unless you hardcode the switch also.

New Member

Re: Understanding SHOW INTERFACE

Do you know where I can get detailed information about the errors (overrun, etc.)?

Regards, L. Schieder

Cisco Employee

Re: Understanding SHOW INTERFACE

This link should help in uderstanding and troubleshooting the same.

http://cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800a7af0.shtml

HTH,Please rate if it does.

-amit singh

178
Views
5
Helpful
3
Replies