cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
8065
Views
0
Helpful
1
Replies

Unexpected exception to CPUvector 700, PC = 0

ccarlosmiguel
Level 1
Level 1

Hi,

Appreciation can help me with this problem. Switch data:

     Cat3750 24TS, IOS c3750-advipservicesk9-mz.122-25.SEB4.

The SW was operating normally then started throwing errors on console and faded.

Then lit the sw to check followed with the problem, the sw decompresses the IOS, but again shows the same message continuously.

Error Messages:

Unexpected exception to CPUvector 700, PC = 0      

-Traceback=

What problem indicates this message?

1 Reply 1

David Hornstein
Level 7
Level 7

Interesting release note on this error that may help, regarding ;

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_20_se1/release/notes/OL633801.html

recovery may be done via the following link;

http://www.cisco.com//en/US/docs/switches/lan/catalyst3750/software/release/12.2_20_se/configuration/guide/swtrbl.html#wp1099467

otherwise sounds like a phone call to Technical Assistance Center (TAC)

regards and good luck Dave

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: