Hello Mukesh,
This is pretty much supported in most of the Metro switch images. The conversion is supported in 12.2(25)SEG and 12.2(50)SE as well.
Please note When you change a port from UNI to NNI or the reverse, any features exclusive to the port type are removed from the configuration to prevent conflicting configuration options on a specific interface type.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet0/1
Switch(config-if)# port-type nni
Switch(config-if)# no shutdown
5d20h: %SYS-5-CONFIG_I: Configured from console by console
Switch(config-if)# end
Switch# copy running-config startup-config
Reference:
http://www.cisco.com/en/US/docs/switches/metro/me3400/software/release/12.2_25_seg_seg1/configuration/guide/swint.html#wp1554661
Thanks,
Ricky Micky
*Pls rate useful posts