I am having one Cisco ME 3400G-12CS switch with 4 NNI port & 12 UNI port.I want to convert all UNI port to NNI to as meet my client requirements.Please guide me which Metro IP Access Image IOS version is required to convert those UNI port to NNI.
This is pretty much supported in most of the Metro switch images. The conversion is supported in 12.2(25)SEG and 12.2(50)SE as well.
Please note When you change a port from UNI to NNI or the reverse, any features exclusive to the port type are removed from the configuration to prevent conflicting configuration options on a specific interface type.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet0/1
Switch(config-if)# port-type nni
Switch(config-if)# no shutdown
5d20h: %SYS-5-CONFIG_I: Configured from console by console
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...