I´m actually working on a Intercom solution that should be able to broadcast the UDP RTP stream to different locations (over the WAN).
Therefore I already tested a behaviour (with NAT) to convert a single UDP stream (that will be send over the WAN) to the destination edge and then convert the UDP stream into a multicast address, where the IP phones are able to receive the stream, here´s the flow:
However, in the second level I want to be able addressing many other locations (e.g. NYC, Boston, etc.), but I´m only able to place one unicast stream. Is there a mechanisms that is able to split one unicast stream into multiple unicast streams?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...