Please see the attached mac-address table of one of my gigabit interfaces of a remote site. I feel something peculiar/wrong with the things happening looking at the output? Can anyone explain me the reason. We don't have much devices connected to this interface.
Thanks for your response. But as I said please have a close look at the mac-address table, it seems like someone is sweeping mac-addresses like 0000.0000.0001, 0000.0000.0002 and so on... I've actually truncated the output, the actual mac-address table is too large.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...