Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Update ARP Table!!

Hi.

4 AP are installed in port POE of switch CE500. Using homing in APs, when notebook leaves a covering area of the AP1 and enters in the area of covering of the AP2 , the switch don't update arp table and the mac of notebooks appears in the 2 ports of CE500.What I can change in switch? They had asked for to me to down the STP, however I believe that this will not decide the problem, I find that this update of MAC who must make is AP. What do you think?

Thanks

2 REPLIES

Re: Update ARP Table!!

Hi,

AP1 wont fwd the frame on the wireless media if the client is not associated to it. The frame will die there. On the switch, the MAC will be aged out after the configure timeout(default is 300 sec).

Does it cause any problem ?

New Member

Re: Update ARP Table!!

With roaming process, the mac is associated in both interfaces ethernet.

181
Views
0
Helpful
2
Replies