Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

update WS-C2950G-48-EI

Hello

I'd like to update IOS of a  WS-C2950G-48-EI.

Now it runs 12.1(22)EA4a. Doku says to use

archive download-sw

But my switch doesn't know this command.

sw78#archive ?
  tar  List or extract files in a tar image

Any ideas?

thanks in advance

Thomas

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions

Re: update WS-C2950G-48-EI

archive tar /xtract tftp://x.x.x.x/iosname.tar flash:

works fine

you also have to set the new image to boot


conf term

boot system flash:.bin

That Great the command work and thanks for the additional input for changing the image to boot. It will be helpful if you can mark this thread as resolved so that other also get beniffitted.

HTH

Ganesh.H

4 REPLIES
New Member

Re: update WS-C2950G-48-EI

If the ios is packeged in a tar file use:

archive tar /xtract tftp://x.x.x.x/iosname.tar flash:

If ios is not packed in tar (ie .bin) use

copy tftp flash:

Re: update WS-C2950G-48-EI

Hello

I'd like to update IOS of a  WS-C2950G-48-EI.

thanks in advance

Any ideas?

sw78#archive ?
  tar   List or extract files in a tar image

But my switch doesn't know this command.

Now it runs 12.1(22)EA4a. Doku says to use

Thomas

Hi Thomas,

Check out the below link for step by step procedure to upgarde IOS for 2900 series switches

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_example09186a0080169627.shtml

Hope to Help !!

Ganesh.H

New Member

Re: update WS-C2950G-48-EI

archive tar /xtract tftp://x.x.x.x/iosname.tar flash:

works fine

you also have to set the new image to boot


conf term

boot system flash:.bin

Re: update WS-C2950G-48-EI

archive tar /xtract tftp://x.x.x.x/iosname.tar flash:

works fine

you also have to set the new image to boot


conf term

boot system flash:.bin

That Great the command work and thanks for the additional input for changing the image to boot. It will be helpful if you can mark this thread as resolved so that other also get beniffitted.

HTH

Ganesh.H

1905
Views
0
Helpful
4
Replies