Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Upgrade 6500 with Redundant Sup

We are deploy a upgrade and we have a doubt

We copy the new ios software to the sup and slavesup. After the reset on the slavesup, it is coming up, we can see the boot process, but the console access stops unexpectedly.

In the Active Sup we can see all status as normal. All working fine. we can´t see the cursor and we can´t the "console inactive messages".

is it a normal behavior in this point of the upgrade process ?

1 REPLY
Cisco Employee

Re: Upgrade 6500 with Redundant Sup

Have you enabled standby console enable command under the main cpu? If not, enable it and do copy run start and try again.

Thanks,

Richard

148
Views
0
Helpful
1
Replies