Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Upgrade C4006 with WS-X4013 supervisor II from CatOS to IOS

Hi expert,

I would like to upgrade the current C4006 chassis with WS-X4013 supervisor II (not WS-X4013+) that currently runs on Cat0S to IOS. Is this possible?

Thanks,

TT

Below is current hardware and catos version:

WS-C4006 Software, Version NmpSW: 6.3(5)

Copyright (c) 1995-2002 by Cisco Systems, Inc.

NMP S/W compiled on Feb 7 2002, 21:00:39

GSP S/W compiled on Feb 07 2002, 18:11:42

System Bootstrap Version: 5.4(1)

Hardware Version: 5.0 Model: WS-C4006 Serial #: FOX05470BQE

Mod Port Model Serial # Versions

--- ---- ---------- -------------------- ---------------------------------

1 2 WS-X4013 JAE0638050X Hw : 5.0

Gsp: 6.3(5.0)

Nmp: 6.3(5)

2 48 WS-X4148-RJ JAE05430407 Hw : 3.0

3 48 WS-X4148-RJ JAB0537084M Hw : 3.0

4 36 WS-X4232-RJ-XX JAE05460344 Hw : 1.6

DRAM FLASH NVRAM

Module Total Used Free Total Used Free Total Used Free

------ ------- ------- ------- ------- ------- ------- ----- ----- -----

1 65536K 33424K 32112K 16384K 5182K 11202K 480K 192K 288K

1 REPLY
Purple

Re: Upgrade C4006 with WS-X4013 supervisor II from CatOS to IOS

Nope you are stuck with catos with that supervisor. You need at least a Supp II+ supervisor to have IOS which comes from the factory . The only switch you can actually upgrade from catos to IOS is a 6500 switch.

860
Views
0
Helpful
1
Replies
CreatePlease to create content