Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrade IOS of stack switches

We need upgrade IOS for our several stack switches. I would like to use “auto-upgrade” feature. I have two questions about it, I hope you could give me some ideas.

According to Cisco document, auto-upgrade is enable by default. But I found the member switches is disable. Could I enable it (boot auto-copy-sw) on member

switches before I upgrade IOS? Could I active it from master switch to type “boot auto-copy-sw”?

If members of switches is active about “auto-upgrade” , could maser switch copy new IOS to members without any additional commands? If it could, do I need to change boot path manually?

Thanks

3 REPLIES
Purple

Re: Upgrade IOS of stack switches

Re: Upgrade IOS of stack switches

I think "auto-upgrade" is just applied when you have IOS mismatch in the stack. If you want to upgrade IOS of whole stack, the procedure in above link should be good.

New Member

Re: Upgrade IOS of stack switches

Got it! Thank you very much!

180
Views
0
Helpful
3
Replies
CreatePlease login to create content