Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Upgrading 3560 from IPBASE to IPSERVICES

We are planning on upgrading a 3560 switch we have that is currently running an IPBASE image (c3560-ipbase-mz.122-25.SEB4) to the same rev but IPSERVICES (c3560-ipservicesk9-mz.122-25.SEB4.bin) Can I just TFTP the new .bin file into flash and change the boot option to this file, or do I have to go thru all the steps to load in the .tar file? Any help is greatly appreciated!

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Upgrading 3560 from IPBASE to IPSERVICES

Hi,

NO.. That's not the way to go from IPBASE to IP SERVICES on 3560.....This can bring your box to a dead state. If you want to go for IPservices to have to buy a licence kit for the same " CD-3560-EMI=". Please go through the link below for more information:

http://www.cisco.com/en/US/products/hw/switches/ps5528/products_qanda_item09186a00801f3d71.shtml

HTH,please rate if it does.

-amit singh

1 REPLY

Re: Upgrading 3560 from IPBASE to IPSERVICES

Hi,

NO.. That's not the way to go from IPBASE to IP SERVICES on 3560.....This can bring your box to a dead state. If you want to go for IPservices to have to buy a licence kit for the same " CD-3560-EMI=". Please go through the link below for more information:

http://www.cisco.com/en/US/products/hw/switches/ps5528/products_qanda_item09186a00801f3d71.shtml

HTH,please rate if it does.

-amit singh

434
Views
0
Helpful
1
Replies
CreatePlease to create content