I have the IOS on a TFTP server, (Laptop), which is connected to the 3560 using a rollover cable to console and a crossover cable in gig 0/1, set up with switchport access Vlan 1. Vlan 1 is configured with ip address XXX.XXX.27.61 255.255.255.0, and default gateway of XXX.XXX.27.1. I really don't think I need the gateway.
Laptop, XXX.XXX.27.60 255.255.255.0 gateway of XXX.XXX.27.1.
I can ping using conslole or telnet to and from XXX.XXX.27.60 and 61.
I can trace only from laptop (27.60) to switch (27.61) but get the 30 hopps going from the switch to the laptop.
Tried to TFTP to laptop with copy runn.... to TFTP and get a time out.
Same results weather I use a crossover cable or a straight thru cable. Get a green light on the switch when either cable is connected.
I can and have up graded the IOS while having another test 3560 connected to the network, I do not want to connect 40 or so switches to the network to do this procedure. Thanks before hand and look forward to finding out what I missed on the configuration. -- Pat
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...