I have upgraded IOS for 6506E Switch to AdvancedEnterprise edition. The IOS is located in CF memory(disk0:) but the problem is when the switch reboot, it did not boot IOS from the disk0 although I enterd the command below already:
boot system disk0:s720xx-advipservxxxxxxxxxxxxxxxx.bin
After backing up the origin IOS(in sup-bootflash) to TFTP server, I deleted it. By now, when the switch reload, it always go in rommon mode and I have to enter "boot" command manually.
Please show me the way to make the IOS in disk0: will be automatically booted in restart process.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...