Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrading a SUP1A-2GE running in hybrid mode

I have 7 6509 chassis with 5 of them using redundant WS-X6K-SUP1A-2GE engines and two running sup 720's. currently I have a mix of CatOS versions running and would like to get them all running the same or at least close versions of CatOS. The 720 sups are running 8.4(5) and the sup 1a's range from 6.3(7) to 7.6(3). Any recommendations?

1 REPLY
Purple

Re: Upgrading a SUP1A-2GE running in hybrid mode

It depends on how much dram you have on the layer 2 side , if its only 64 meg you are limited to 7.5 or below . If you have 128 then it looks like 7.6.17 was th elast version before the card went end of life...

120
Views
0
Helpful
1
Replies