Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Upgrading IOS on 3750 stack

All,

I have to upgrade our IOS on a 3750 stack. Do I upgrade the IOS on the master stack, reload the stack, and then the others will copy the IOS automatically from the master?

Thanks,

John

HTH, John *** Please rate all useful posts ***
2 REPLIES
New Member

Re: Upgrading IOS on 3750 stack

I stack should be on the same IOS at this time. When you apply the upgrade to the stack master it will be copied to all the switches in the stack. Reload the stack and all the switches will be on the new IOS.

The link below will give you a detailed step by step process.

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_example09186a00804799d7.shtml#maintask1

Sal Marino

Gold

Re: Upgrading IOS on 3750 stack

In theory that is how it should work.

However since murphy exists I do the following when upgrading.

copy the IOS bin file (I do not use the http interface) to each and every one of the flashes in the stack.

flash1:/

flash2:/

flash3:/ and so on.

Set the boot to the proper ios for all the switches in the stack.

If this is the first time you upgrade the switches I would recomend my way to do it since IF there is a faulty flash you will get an error and have time to get another one to replace it before reloading the switches. (we found 2 in our environment)

as an added bonus you will get shorter stop time. ie the copying of the files to the flash is already done and the system will reload and come up in around 3.5-4 minutes depending if there are any upgrades in the microcode.

445
Views
0
Helpful
2
Replies