Did you check to make sure you had adequate hardware memory requirements before upgrading ? That new version is a lot bigger than the one you are replacing . Newer images like sxf7 do not require a bootloader image .
Please paste the "show version" from the switch If you have.
I hope that you have checked these requirements:
Supervisor Engine 2 with PFC2:
?ROMMON version 7.1(1) or later
?32-MB bootflash device
?256-MB DRAM (minimum)
Multilayer Switch Feature Card 2 (MSFC2) with 256-MB DRAM (minimum)
?Some Supervisor Engine 2 Release 12.2SX images are larger than the bootflash device. Supervisor Engine 2 ROMMON version 7.1(1) or later supports the MEM-C6K-ATA-1-64M= (64 MB) PCMCIA ATA FlashDisk device. See this publication:
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.