Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

uplink 3550 with 2950

Hi,

i have a network that consists of 2950.

I'm using a crossover cable to connect a port from the 2950 and connect the other end to a 3550 and make the new switch part of the vlan that's configured on the 2950.

For some reason, i can't get it to work, anybody know why??

thx

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: uplink 3550 with 2950

Can you provide the configs of each? What did you setup to make it work? Did you setup the link as a trunk? Did you setup VTP? etc.

2 REPLIES
Community Member

Re: uplink 3550 with 2950

Can you provide the configs of each? What did you setup to make it work? Did you setup the link as a trunk? Did you setup VTP? etc.

Community Member

Re: uplink 3550 with 2950

Hi sdrossen2,

I found my problem, the 2950 port was engaging in a trunk mode.

problem fixed.

thx for your help.

138
Views
0
Helpful
2
Replies
CreatePlease to create content