I have a question that I know this community can assist with. I am connecting two sites for a customer over a fiber uplink. The provider has configured their fiber switch and we just need to do a copper uplink to our switches. At site A this connection goes to a 3560-G. At site B the connection goes to a 4507. I have configured site B as a no switchport with an IP. At site A the connection is a switchport in trunk mode. The data gets across with no issues but I have a need to enable multi-casting for Informacast to send its audio across. I have enabled IP PIM SPARSE-DENSE-MODE on the 4507 but I dont know what to do on the 3560 side. I did mirror the configuration on the 3560 just like the 4507 (with a different IP) but I was not able to get all traffic to pass. Phones did not register and users were unable to hit the web or internal resources. Site A is a school district office and site B is a school.
Currently the site is up and running but multicast is not working.
Any guidance on how to configure the two ends would be appreciated.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.