My Network is two 6500 series switch one of them run CATos the problem start when upgrading when of them to run IOS and change the supervisor engine to a new one the active is the one run IOS and the standby is the Catos we have in both fibre module that run up link to the edge switches anf the core switches.
the problem :
we start to face slow network response on random edge switches connected to the fibre of the active core and so on with other switches,so we have checked everything nothing worng or any modification have been done no erridisable port no errors we have changed hardware checking bugs follow all the solution monitor the network ,when I put a crossover cable between on of the switches and the BB it eorks fine I am confused I appreciate your helps,regards
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...