Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Uplinks on WS-X45-Sup6L-E supervisor engine

With the WS-X45-Sup6L-E supervisor engine, is it possible to use one of the uplink ports with the X2 optics for 10G speeds and the other port with a Cisco Twin Gigabit ?

3 REPLIES

Hey,It is not supported due

Hey,

It is not supported due to hardware limitation. Check the link below:

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/44sg/configuration/guide/Wrapper-44SG/sw_int.html#wp1084402

HTH.

Regards,

RS.

i have made some

i have made some configuration that make me supose that it is posible 

 

CAT4K-HUB01_10GB_TEP#sh hw-module module 1 port-group 
Module Port-group Active                         Inactive
-------------------------------------------------------------
   1        1     Gi1/3-4                        Te1/1                         
   1        2     Te1/2                          Gi1/5-6                       

CAT4K-HUB01_10GB_TEP#sh interf status module 1        

Port      Name               Status       Vlan       Duplex  Speed Type
Te1/1     HUB01-PO1-CTC-20GB inactive     1            full    10G No X2
Te1/2     HUB01-PO1-CTC-20GB notconnect   1            full    10G No X2
Gi1/3     LIBRE              notconnect   1            full   1000 No Gbic
Gi1/4     LIBRE              notconnect   1            full   1000 No Gbic
Gi1/5     LIBRE              inactive     1            full   1000 No Gbic
Gi1/6     LIBRE              inactive     1            full   1000 No Gbic

My bad, I misinterpreted the

My bad, I misinterpreted the question.

Its fully supported. You may use the 10G and 1G on different port-groups.

Regards,

RS.

195
Views
0
Helpful
3
Replies
CreatePlease to create content